Mb-quart MX-4 Bedienungsanleitung PDF herunterladen (Seite 9)

MX-1 Connecting High Level Speaker Wires (with factory amp)

BASS REMOTE

High Level Speaker Wire Connections

1. Cut ( )the factory amplifier speaker wires coming from the amp to the speakers in half.

2. Connect the speaker wires from the amp to the MX-1 as show in the diagram on this page.

3. Connect the other end of wires from the speakers to the aftermarket amplifier as shown in

the diagram on page ?

4. If you experience audible noise (distortion) in the speakers upon completion of the installation,

connect the MX-1 “Radio” ( )ground to the factory radio ground wire as shown above.

SPEAKER WIRE INPUT

+ - + - + - + - + -

R/F L/F R/R L/R SUB RADIO

MXR-1 REMOTE

CONTROL

cut

Factory Radio

High Level Speaker Wire Outpus

SUB L/R R/R L/F R/F

GND

+ - + - + - + - + -

Factory Amplifier

VOLUME

MIN MAX

GREEN: PRE-CLIP

YELLOW: SOFT CLIP

RED: HARD CLIP

MXR-1

Connect this end of the speaker

wires to the amplifier

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Keine Kommentare

Mb-quart MX-4 Bedienungsanleitung Seite 9