Part No. 13954 Rev.AFOODSERVICE DISPOSERInstallation Manualwww.insinkerator.com/foodservicePlease be certain that the person who installs or uses this
10Operating InstructionsOPERATING THE DISPOSER1. Make sure there are no foreign objects in the disposer grind chamber. Do not pre-load the disp
11ELECTRICAL SHOCKDisconnect power before servicing.TroubleshootingTroubleshooting for problems other than what is listed below should be performed by
2Table of ContentsIntroduction Introduction ... 3 Clean the Drain
Introduction3INTRODUCTIONThe InSinkErator Foodservice food waste disposer is UL® and CSA® Listed when installed in conjunction with InSinkErator mount
Installing the Disposer4Figure 2. Distance from Table Top to Mounting FlangeMOUNTING ADAPTORSThere are two adaptor categories for mounting InSinkErato
5Standard InSinkErator Mountings#5 MOUNTING ASSEMBLYFollow these instructions to install a #5 sink flange to a standard 3-1/2 to 4 inch sink opening.1.
6Standard InSinkErator Mountings1. Place the mounting flange (1) over the existing collar adaptor connection lip or sink bowl flange (this may requir
7PROPERTY DAMAGE These plumbing instructions were written for an experienced competent installer. If the installer is not experienced in plumbing i
8Standard Motor Connection Wiring DiagramsNOTE: The diagrams below show standard motor connection wiring for a manual switch operation. For alternate
9ELECTRICAL SHOCK • Turn off the electrical supply to the disposer before servicing. Test the circuit with a voltmeter or circuit tester to ensure the
Kommentare zu diesen Handbüchern